![]() Target halted due to debug-request, current mode: Thread Guess I may need to read some instructions for that. It seems the program is sent but it doesn't run (simple blink test), but if I burn boot loader again, it starts running as it should, so I guess its something I am doing wrong. New problem (which I haven't searched yet) is uploading sketch using programmer. I can burn boot loader to the custom board, it shows up in the Tools>Ports list now. So, it seems to be a permission problem, running the IDE ans root solves that problem. This report would have more information with I would like to just use the Arduino IDE if possible so any help would be appreciated.Īrduino: 1.8.9 (Linux), Board: "Arduino MKRZERO" It does work using Atmel studio 7, read memory from a real MKRZero, write to my board, so I don't think its a connection/board/fuse problem. I am using the same SWD connection as J8 on the MKR-Zero boards, 3V3, GND, SWDIO,SWCLK,RESET. So I am trying to use the Arduino IDE to burn the boot loader on some boards I made with the Atmel-ICE, and I get an error "Error: unable to open CMSIS-DAP device 0x3eb:0x2141" (full error at bottom). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |